1/10 HP Variable Speed Drive Motor + Control + 3/8" / 10mm Chuck 800-8000 RPM

Description

This is a p
lug & play
1/10 HP Variable Speed Drive with Motor + Control
+
13/32" Keyed Drill Chuck
800-8000 No-Load RPM 115V.
Here are the details:
1/10 HP Variable Speed Drive with Motor + Control + 13/32" Chuck
Universal AC/DC motor
800-8000 RPM Approximate NO-LOAD speed range (runs slower under load)
110 Volt / 1.5 Amp
Variable speed control for AC/DC motor
Plug + Play...no wiring required
Motor has (2) 10-32 mounting holes on each flat side
With 13/32" / .406" / 10.3mm capacity keyed drill chuck
Included (2) 10-32 x 1" bolts with jam nuts
Output shaft is 1/4" diameter x 1/2" long with flat
CW Rotation (non-reversible)
Approximately 13 inch/ounces of torque at full speed (much less torque at low speed)
Variable speed control is switchable to "VARIABLE" speed, "FULL" speed or "OFF"
Motor cord is 1-1/2 feet long
Speed control cord is 6 feet long
Please see item specifics above for more motor data
Please study the pictures & specs carefully and email with any questions...thanks for stopping by.
FAST Shipping Included in the USA.
Safety Note: It is the buyer's responsibility to determine if this high speed motor is suitable for your application, to mount it securely, and to operate it in a safe manner. Failure to do so may cause injury.
Shipping weight is 3-1/4 lbs.